...10GbE をサポートする CAT6 や光ファイバで高速伝送、最高のパフォーマンスを実現 • プロスイッチの特長 • プロスイッチシステムは、リレーと専用マイクロミラーを使って電気的 / 光学的に通信経路を接続・切断しています。経路切断は物理的なエアギャップ絶縁で実現しています。 • データ転送速度、フォーマット、プロトコルは影響しません。 • 電源 OFF の状態でもデータを送信し続けます。 • 主な切替パターン • AB 切替 • ABC 切替 • カスケード切替 • ...

Gigabit Ethernet • Gigabit Ethernet • As workstations and servers migrated from ordinary 10-Mbps Ethernet to 100-Mbps speeds, it became clear that even greater speeds were needed. Gigabit Ethernet was developed for an even faster Ethernet stan...

...when using Cat5e or Cat6 cable you may need a product that compensates for skew/colour drift, and you should always use solid core cable, and shielded cable if recommended in the product specifications. You can find more information about these ...

...those. • It takes 90.87 seconds for switches in non redundant networks to recover from power interruptions. • 45% of all data loss is caused by power problems. • More than 70% of servers are protected with a UPS • For a small fraction of the c...

The MPO connector • The MPO connector • MPO stands for multifiber push-on connector. It is a connector for multifiber ribbon cable that generally contains 6, 8, 12, or 24 fibers. It is defined by IEC-61754-7 and EIA/TIA-604-5-D, also known as ...

SCSI-1, -2, -3 and -5 • SCSI 1, 2, 3 and 5 connectors • The original SCSI standard was approved in 1986. It supports transfer rates of up to 5 Megabytes per second (MBps) and 7 SCSI devices on an 8-bit bus. The most common connector for SCSI-1...

Fibre Channel Technology. • Fibre Channel Technology • What is Fibre Channel? • Fibre Channel is a set of communication standards designed to provide high-speed data transfer over a duplex, serial interface. It’s an open standard that supports...